DigiDesign ADAT Bridge I/O User's Guide download pdf (Page 24)

ADAT Bridge I/O20

Setup C: Synchronizing Pro Tools and ADAT using the MTP AV

The Mark of the Unicorn MTP AV provides

extensive MIDI and sync capabilities, and

you can use it to synchronize your

Pro Tools/ADAT system. In this role, the

MTP not only translates MMC from

Pro Tools to ADAT sync (allowing Pro Tools

to be the positional/transport master) but it

also serves as the clock master (in fact, it

must be the clock master).

To connect this system:

1 Connect a 9-pin cable from the MTP AV’s

ADAT 9-pin Sync Out” port to your pri-

mary ADAT’s 9-pin Sync In port.

2 Connect “256x clock OUT” from the

MTP AV to the “Slave Clock In” port on the

ADAT Bridge I/O.

3 Make sure that the serial connection

from the MTP AV to your CPU is correct.

MTP AV Settings:

◆ MTP AV clock must be set to Internal.

◆ Word Clock Out must be set to “Digi”

◆ The MTP AV’s MMC ID must match

Pro Tools. You will learn how to set the

Pro Tools MMC ID in Chapter 3: Using

your Studio.

☞ For additional instructions for this set up,

see

Chapter 3: Using Your System” and

“Setup C: Conﬁguring Pro Tools and ADAT sync

with an MTP AV” on page 45.

Figure 5. WIring Example for the MTP AV

Computer

to Pro Tools card

256x clock signal, to ADAT Bridge Slave Clock IN

256x clock signal (MTP AV out)

Interface Y-cable

serial cable to

modem or printer port

Mark of the Unicorn MTP AV™

ADAT 1

ADAT 2

Digidesign ADAT Bridge

optical cables in/out

Pro Tools card

50-pin

interface cables

9-pin ADAT Sync cable

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 63 64

Comments to this Manuals

No comments

DigiDesign ADAT Bridge I/O User's Guide Page 24

Comments to this Manuals

Related products and manuals for Recording Equipment DigiDesign ADAT Bridge I/O