DigiDesign ADAT Bridge I/O User's Guide download pdf (Page 52)

ADAT Bridge I/O48

10 In the Pro Tools Session Setup window,

choose the sample rate that matches the

material on the ADAT(s).

11 In the Pro Tools Session Setup window,

check and enable the MTC to Port button,

then select the Digital TimePiece’s OMS

port in the pop-up that appears below this

button.

12 In the Pro Tools Session Setup window,

choose the SMPTE frame rate that matches

the rate chosen on the Digital TimePiece.

13 Create the number of destination audio

tracks you wish to transfer from the

ADAT(s). Make sure the destination tracks

each have a different voice assignment in

the Pro Tools session.

14 Use the Input Selector of each destina-

tion track to assign its input. Inputs 1-8

correspond to the ADAT Bridge I/O’s Group

A inputs. Inputs 9-16 correspond to ADAT

Bridge I/O’s Group B inputs. If you have ad-

ditional ADAT Bridges/ADATs, assign their

inputs as well. (When Ch 1-2 input set to

ADAT, Pro Tools automatically sets I/O

pop-ups to ADAT Bridge Group A/B input

& output labels.)

15 Select a Pro Tools monitoring mode

(Auto Input Monitor or Input Only Moni-

tor). Use Input Only Monitor if you wish to

be able to hear incoming material on

record-enabled Pro Tools tracks before you

initiate recording. Use Auto Input Monitor

to hear incoming material only during ac-

tual recording.

16 Choose Time Code from the Pro Tools

Display menu so that the Pro Tools counter

will display time in SMPTE frames.

17 Choose the desired Pro Tools online re-

cording mode: Record Online at Time Code

Lock, or Record Online at Insertion/Selec-

tion. To do this, choose Preferences from

the Pro Tools Setups menu. Click the Oper-

ation button and enable the desired mode

at the bottom of this dialog. If you are not

familiar with these modes, refer the expla-

nation in your Pro Tools Reference Guide.

18 Set the Pro Tools pre-roll time to at least

10 seconds.

19 Click the Pro Tools Record button

20 Click the Pro Tools Play button.

21 When you have ﬁnished recording,

click Pro Tool’s Stop button. The ADAT will

stop recording.

Recording Tracks from Pro Tools to

ADAT with a Digital TimePiece

This setup explains how to perform a syn-

chronized Pro Tools-to-ADAT track transfer

using the Digital TimePiece.

To transfer audio from Pro Tools to ADAT:

1 Make sure your DTP is conﬁgured as de-

scribed in the previous ADAT-to-Pro Tools

setup.

2 Make sure that the ADAT tape is format-

ted to the same sample rate as the Pro Tools

material you intend to transfer.

3 On the ADAT, record-enable the destina-

tion ADAT tracks. Make sure that the same

tracks are not conﬁgured as Pro Tools input

sources or a feedback loop will occur.

4 In Pro Tools, open the session with the

audio you wish to transfer to the ADAT.

5 In the Pro Tools Session Setup window,

set Channel 1-2 input to ADAT.

6 In the Pro Tools Session Setup window,

set the Pro Tools Sync Mode to Internal.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 63 64

Comments to this Manuals

No comments