DigiDesign D-Control Specifications download pdf (Page 32)

D-Control Guide24

Installing the Units on the Stand

After the D-Control Main Unit and Fader Modules are pre-

pared for installation, the units are placed on the stand in the

appropriate order for your configuration. Install the units

from left to right on the stand.

To install the D-Control units on the stand:

1 Lift the first unit into place on the stand so the channels in

the bottom of the unit go over the rear and front rails of the

stand.

2 Slide the unit to the left side of the stand, leaving a gap of

about an inch (2 cm) between the side of the unit and the

flange on the inside of the stand.

3 Lift successive units into place on the stand, being careful

not to bend the pins in the units you installed previously.

4 Slide the units together, guiding the pins in each unit into

the corresponding holes in the side of the next unit.

5 Attach the units to the front and rear rails from below with

M6 x 8mm Phillips pan head screws, using a total of 6 screws

for the Main Unit (3 each in the front and rear rails) and a total

of 4 screws for the Fader Module (2 each in the front and rear

rails). Make sure to leave these screws loose enough so that the

units can still move side-to-side relative to the rails.

Figure 23. Placing a Fader Module on the stand

Figure 24. Leaving a gap between the unit and stand

Figure 25. Attaching a unit to the rails from below

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 163 164

No comments

DigiDesign D-Control Specifications Page 32