DigiDesign D-Control Specifications download pdf (Page 12)

PRE Guide8

Source Switch and LEDs

This switch sets the active input source for indi-

vidual PRE channels to Mic, Line, or Inst (instru-

ment). The three Source LEDs indicate the active

input.

Input Impedance (Represented as Z)

The Input Z switch sets the input impedance for

a PRE channel to 1.5 k, 15 k, or 1.5 M.

The three Input Z LEDs indicate the current set-

ting:

1.5K Typically used for microphone inputs, this

is the default setting when Source is set for Mic.

15K Typically used for line level inputs, this is

the default setting when Source is set for Line.

1.5M Typically used for instrument inputs, this

is the default setting when Source is set for Inst.

To change input impedance, do one of the

following:

 If the input Source is Mic, press Input Z once

to change to the next setting, or multiple times

to toggle through the three settings.

 If the input Source is Line, press Input Z to

change to 1.5K or 15K.

 If the input Source is Inst (instrument), the In-

put Z cannot be changed from its default 1.5M

setting.

Channel Status Section

Each PRE channel provides switched control for

48V (phantom power), phase reverse, input pad,

access to a unity gain insert send/return, and a

high-pass filter. In addition, all eight channels

have individual Mute switches and signal status

LEDs.

Signal Present/Clip (SIG) LEDs

These LEDs indicate the status of a channel’s in-

put signal. Green indicates signal is present

(–45 dB) and red indicates clipping. When there

is no signal present or the signal is below –45 dB,

the LED is off.

When clipping occurs, the LED remains lit or

clears, depending on the Peak Hold setting.

Clips can also be manually cleared with the

Clear Clip switch.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 49 50

Comments to this Manuals

No comments

DigiDesign D-Control Specifications Page 12

Comments to this Manuals

Related products and manuals for Recording Equipment DigiDesign D-Control