DigiDesign D-Control Specifications download pdf (Page 14)

PRE Guide10

Channel Mute Switches and LEDs

Each PRE channel has a dedicated Mute switch

to mute input signal. The respective Mute LED

lights when muting is enabled.

Channel Select Switches and LEDs

These switches are used to “focus” one or more

channels to adjust their controls. When lit

(green), the Channel Select LED indicates that

the channel’s controls can be adjusted.

To select multiple channels for adjusting, first

press the Shift key on the left-hand side of the

unit, then press the Select switches for corre-

sponding channels. To return to single channel

selection, disengage the Shift key, then press the

Select switch for the individual channel you

wish to change.

The following channel controls can be adjusted:

• 48V Phantom Power; see “48V Switch and

LEDs” on page 9.

• Phase Reverse; see “Phase Switch and

LEDs” on page 9.

• Pad; see “Pad Switch and LEDs” on page 9.

• Insert; see “Insert Switch and LEDs” on

page 9.

• High-Pass Filter; see “High-Pass Filter

Switch and LEDs” on page 9.

• Mic/Line/Instrument Source Switching; see

“Source Switch and LEDs” on page 8.

• Input Gain; see “Gain/Param and Input

Gain” on page 15.

When PRE is powered off, channel select states

are stored in memory and are subsequently re-

stored at power up.

Line/Inst 1 and 2

The front panel includes two 1/4-inch

balanced/unbalanced TRS jacks, with Tip wired

hot (or “+”), Ring cold (“–”), and Sleeve ground.

These jacks mirror Line/Inst Inputs 1 and 2 on

the back panel. Connecting to the front panel

Line/Inst input will break a connection made to

the respective back panel Line/Inst input.

Use these jacks for convenient access to high im-

pedance instrument inputs.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 49 50

Comments to this Manuals

No comments